Simple knowledge of installation of submersible pump unitThe installation procedure of the submersible pump unit is as follows.Install the pump in the section of the water outlet of the submersible pump, and a splint to lift that falls into the well, located in Jingtai splint.Then use a splint to hold the other pipe. Then lift, lower and connect the water pipe flange pad, screw must be diagonal at the same time. The chain rose removal of the first splint, the splint and the pump down well. In turn, repeated installation, down well, until all installed, put the manhole cover, the last payment of plywood is not removed, put it on the manhole cover.Install the elbow, gate valve, water outlet and so on, and add the corresponding rubber gasket seal.The cable should be fixed on the pipe flange on the groove, with no rope fixed, when drilling to be careful, shall not damage the cable. If the pump in the process of blocking phenomenon, we must think of customer service card point, you can not force the pump, so as not to die.Installation is strictly prohibited personnel down the well operation.The protective switch and the starting device shall be installed in the user's power distribution after the switch, the switchboard has a voltmeter, ammeter, indicator light, and placed in the appropriate location of the well.The "force protection measures from the motor base to the ground wire tube bundle", to avoid the accident happen.